SerVision CVG-M Guide d'installation télécharger pdf (Page 29)

SerVision CVG-M Installation Guide

Connecting the GPS Antenna 28

Connecting the GPS Antenna

A GPS receiver is built into the CVG-M unit. When the GPS antenna is connected to the unit, this receiver can be

used to track the location of a vehicle in which the CVG-M is installed.



To connect the GPS antenna:

1. Connect the supplied GPS antenna cable to the GPS Antenna connector on the side of the unit.

2. Place the other end of the antenna as high up as possible in the vehicle or on the roof of the vehicle. Make sure

the box at the end of the antenna is horizontal and is facing up (smaller side up). If possible, place it in a

location in which there are no obstructions between it and the sky.

Figure 26: GPS antenna cable

The box at the end of the antenna contains a magnet with which you may be able to attach it to the roof of the

vehicle. Alternatively, you can attach it in its intended location with double-sided tape. Regardless of which

method you use, make sure the antenna is attached securely to the vehicle so that it will not come loose when

the vehicle moves.

Box facing up

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Pas de commentaire

SerVision CVG-M Guide d'installation Page 29