SerVision CVG-M Guide d'installation télécharger pdf (Page 8)

SerVision CVG-M Installation Guide

Installing the CVG-M System 7

Installing the CVG-M System

These are the steps that you will typically follow in order to install the CVG-M system:

1. Insert the SIM card into the SIM-card slot; see Inserting the SIM Card, page 26.

2. Place the CVG-M unit in its desired location; see Selecting a Location for the Unit, page 7.

Note: If you are installing the CVG-M in an insulated container (see Preventing Overheating, page 8), you

must install the container in the vehicle and the CVG-M in the container.

3. Install the video cameras in their desired locations.

4. Install a CCTV monitor in its desired location (optional).

5. Install either a dry sensor, a toggle switch (for outline switching), or a push-button switch (for changing the

display on a connected CCTV monitor) in its desired location (optional); see Connecting Sensors, page 16.

6. Install an alarm or other activator in its desired location (optional); see Connecting an Activator, page 20.

7. If you are using either an ADAM module to connect additional sensors to the CVG-M, install the sensors in

their desired locations (optional); see Connecting Sensors, page 16.

8. If you are using an IA relay board to connect additional sensors or activators to the CVG-M, install them in

their desired locations (optional); see Connecting Sensors and Activators Using an IA Relay Board, page 21.

9. Connect the cameras and other devices to the CVG-M, as required; see Connecting Devices to the CVG-M,

page 14.

10. Connect the unit to a LAN using an Ethernet cable (optional); see Connecting the CVG-M to a Network,

page 26.

11. Install the GPS antenna in an appropriate location in the vehicle and connect it to the unit (optional); see

Connecting the GPS Antenna, page 28.

12. Connect the cameras and other devices to the vehicle battery, as required; see Supplying Power to Devices

Connected to the Unit, page 11.

13. Connect the CVG-M unit to a power source; see Connecting the CVG-M to a Power Source, page 29.

NOTE: If the unit is being installed in a vehicle, the devices connected to it, and the cables used to connect

them, must all be securely fastened to the vehicle to ensure they do not become detached from their

locations when the vehicle is in motion.

NOTE: Installing the unit and its peripheral equipment in a vehicle is a complex process. It is highly

recommended that it be performed by a trained specialist in vehicle installations.

Selecting a Location for the Unit

The CVG-M unit should be placed on a flat surface such as a shelf. (It is not designed for mounting directly on a

wall.) If it is being installed in a vehicle, the unit should be installed in a cool and ventilated location, protected

from direct sunlight and water (including liquids used to clean the inside of the vehicle), and as far away from

humidity as possible. It should not be installed in a closed location, such as the in the trunk or dashboard, or under

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Pas de commentaire

SerVision CVG-M Guide d'installation Page 8