HVG400 Installation Guide
Connecting Devices to the HVG400
Flat ribbon cable with D-type 9-pin female connector on one end and a D-type 9-pin male connector on the
other end
Wire to connect the ADAM module to the ADAM converter – red, black, yellow, and green
Wire and an electrical plug (optional) to connect the ADAM module to a power source
Figure 6: ADAM-4051 module
Figure 7: ADAM-4520 isolated converter
NOTE: The instructions below explain how to connect sensors to the HVG400 using the ADAM module and
converter described above. For additional information about connecting and configuring the ADAM
module and converter, please refer to the manufacturer's documentation, or contact your vendor.
To
connect sensors using
an
ADAM
module:
1. Install the sensors in their desired locations in accordance with the manufacturer's instructions.
2. Connect the wire contacts of each of the sensors to the terminal blocks of the ADAM-4051 module as follows:
Connect all of the negative (-) wires of all of the sensors to one of the ground (D GND) connectors on the
ADAM module. If the wires cannot all be inserted into the connector, use a wire connector to connect them
together, and then connect the wire connector to the ground (D GND) connector on the ADAM module.
Connect each of the positive (+) sensor wires to one of the numbered connectors (D1 0 through D1 15) in
the terminal blocks of the module.
Commentaires sur ces manuels