SerVision MVG 400 Guide d'installation télécharger pdf (Page 19)

PVN SerVision

HVG400 Installation Guide

Connecting Devices to the HVG400

activate PTZ controls (if available). For additional information, please refer to the Embedded Video Gateway

System Guide.

NOTE: Only the mouse supplied with the HVG400 is supported. If you connect a different mouse, the mouse

may be damaged.



connect

the mouse:

 Plug the mouse into the Mouse Connector on the rear panel of the unit.

Connecting a Switch

If you wish, you can connect a switch to the unit to change the display on the monitor. The switch must be connected

to the Sensor 6 (In6) connector. For additional information, see Connecting Sensors, page 10 and refer to the

Embedded Video Gateway System Guide.

Connecting Multiple Monitors

If you wish, you can connect multiple CCTV monitors to the HVG400. For example, you may wish to have one

monitor beside a check-out counter, and another in the manager's office.

To connect multiple monitors, you must use video splitters to split the connection. Bear in mind, however, that the

image quality in each of the monitors will be slightly degraded. To correct this problem, you can use a video

amplifier (booster) for each monitor. To ensure you have the correct equipment, consult a video equipment supplier.

Note, also, that only one mouse can be connected to the unit. This means that there is only one point of control over

the display, and the display will be identical on all connected monitors.

1 2 ... 14 15 16 17 18 19 20 21 22

Pas de commentaire

SerVision MVG 400 Guide d'installation Page 19