SerVision CVG-M Informations techniques télécharger pdf (Page 162)

SerVision Embedded Video Gateway System Guide

Resetting the Unit 161

Resetting the Unit

You can reset the unit at any time. Resetting the unit may help if video streaming is unreliable or frequently

interrupted. In addition, most configuration changes you make are only fully implemented after the unit is reset. If

changes were made to the configuration of the unit, and the changes were saved on the unit, but the unit was not

reset afterwards, the changes are implemented when the unit is reset. Resetting does not cause any settings to be lost

or restored to their default values.

The unit can be reset in one of the following ways:

 Through the configuration utility

 By unplugging the unit from the power

On MVG and UVG units, resetting the unit also resets the router. If you wish, you can reset the router without

resetting the unit. While the router is restarting, you will not be able to connect to unit, but it will continue to record

video and event information.



To reset the unit using the configuration utility:

1. Log into the configuration utility (see Opening the Configuration Utility, page 9).

2. In the Main Menu, under System, click Restart. The System Restart Page opens.

3. Click Restart System. The unit restarts.



To perform a power reset:

 Unplug the unit from the power and then plug it in again.



To reset a SerVision router:

1. Log into the configuration utility (see Opening the Configuration Utility, page 9).

2. In the Main Menu, under System, click Restart. The System Restart Page opens.

Figure 188: System Restart Page with Restart Router button

3. Click Restart Router. The router restarts.

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 202 203

Pas de commentaire

SerVision CVG-M Informations techniques Page 162