SerVision CVG-M Informations techniques télécharger pdf (Page 172)

SerVision Embedded Video Gateway System Guide

Appendix A: Viewing Video on a CCTV Monitor (TV-Out) 171

Figure 194: Full-screen display

When the Video Gateway unit starts up, the monitor displays a startup screen containing the name of the unit, its

private IP in the local network, the firmware version, and a video pane displaying live video from one of the

cameras connected to the unit. If mouse/touch is activated, a Done button also appears. After a few seconds, this

display is replaced by the default video display.

Figure 195: Startup screen

NOTE: If the unit is configured to connect to an external LAN using DHCP (see LAN Settings, page 38),

[DHCP] appears after the IP address. If the IP address was not yet assigned when the startup screen was

displayed, 0.0.0.0 appears instead of the IP address. If mouse/touch controls are available (see below),

you can see the correct IP in the Sys Info screen (see Viewing System Information on the Monitor,

page 196) after it is assigned.

The default display can be changed on the fly using one or both of the following methods:

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 202 203

Pas de commentaire

SerVision CVG-M Informations techniques Page 172