SerVision CVG-M Informations techniques Page 165

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 203
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 164
SerVision Embedded Video Gateway System Guide
Restoring Factory Settings 164
Figure 192: Jumper connected to pins 2 and 3
4. Reconnect the power to the unit. When the startup process is completed (the Power LED on the front of the
unit flashes at frequent intervals), the default factory settings are restored.
5. Disconnect the power from the unit again.
6. Remove the jumper from the RS232/485 connector.
7. If you disconnected a PTZ controller before performing this procedure, reconnect the controller.
8. Reconnect the power to the unit.
Vue de la page 164
1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 202 203

Commentaires sur ces manuels

Pas de commentaire