SerVision MVG 400 Guide de l'utilisateur télécharger pdf (Page 69)

SerVision MVG 400 System Guide

Configuring the MVG 400 69

You can configure an access point even if no wireless card is connected to the unit, or when

the access point is not within range of the unit. When a wireless card is installed, you can use

it to help you add the access point, because it can detect all of the access points that are within

range of its current location. It then automatically supplies the SSID of the access point.

The unit does not have to be restarted before the wireless connection is established. This

makes it possible to quickly test the settings. Nevertheless, it is important to save the settings

once they are correctly configured. Otherwise, the settings will be erased when the unit is next

restarted.

NOTE: Unless you have made other changes to the system configuration that are only

implemented after the system restarts, it is not necessary to restart the system after

the WiFi settings are saved.

To configure an access point with a WiFi card connected to the unit and

the access point in range:

1. In the Main Menu, under System, click WiFi. The WiFi Configuration screen opens. The

screen displays a list of access points that have been detected within range of the unit.

(This may take a minute or two.) For each access point, the list indicates whether it

requires an encryption key, and how strong the signal received by the unit from the

access point is.

Figure 56: WiFi Configuration screen when a WiFi card is connected to the unit but

no access point has been selected yet

Note: If you install a WiFi card when the unit is running, you must restart the unit to

access the wireless networks.

2. If the access point to which you want the MVG 400 to connect requires a WEP

encryption key, in the line in which the access point appears, under Key, fill in the

encryption key.

3. In the line in which the access point appears, click Update. The access point is selected,

and marked “In Use,” and the MVG 400 connects to the wireless network. From this

point on, whenever the MVG 400 unit comes within range of the access point, it will

automatically connect to it.

List o

detected

access points

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 189 190

Pas de commentaire

SerVision MVG 400 Guide de l'utilisateur Page 69